Showing 40 results

Dark olive green cotton and wool detachable hood with fur trim to be worn with Parka Shell 2020.74.1. The outer hood is made of dark olive green cotton with a wired brim edge. It has a double layered neck flap and drawstring around the inner brim with leather stoppers and an elastic loop across the top of the hood. There are four button holes around the bottom edge of the neck flap to fasten to the parka shell and two large plastic buttons on the right side of the flap.

The inner edge of the brim is trimmed with brown animal fur. The inside of the hood is made of dark olive green wool or wool and cotton mix. The manufacturers label is stamped in orange ink to the inside of the outer neck flap (half of it has worn away).

Dark olive green cotton parka with hood - to be worn with liner 2020.74.2 and fur trimmed hood 2020.74.3. The parka fastens centre front with a heavy silver coloured metal zip, with 'CONMAR' etched into the zip head, and seven metal press studs with 'UNITED CARR' etched into the back. It has two large angled flapped pockets on each side of the centre opening at waist level and a U.S. ARMY label in yellow on black sewn on to the left chest. There are drawstrings at the waist, around the hood, and around the bottom hem. The hood drawstrings have leather stoppers.

The back of the parka is longer than the front and curves to a point with a small V creating the 'fishtail'. The inside has green plastic buttons around the sides, neck, hood and cuffs to button on the hood liner and body liner. The sleeve cuffs fasten with an elasticated pull tab and large olive green plastic button.

Handwritten in dark pen inside the back of the neck is 1-HQ209. Manufacturers stamp in black on the inside of the hood at the back of the neck.

Short purple coat with down feather interlining, pink lining and hood (production sample including re-used linings from left-over fabric from previous seasons). The parka has ultrasonic welded seams. It closes centre front with a zip and a double flap wind protection covering which closes with magnetic fastenings. At the neck of the hood are two purple '7L' press stud fastenings and there is one at the bottom hem. Each side has two waterproof zipped pockets, one horizontal, one vertical. The end of all zips have a matt garage to ensure waterproof quality. There is also an invisible zipped pocket above the vertical pocket.

The hood has a stiff peak insert, and two stoppered elastic draw cords. There is another draw cord around the waist, which feeds down a channel sewn into the centre front facing. There is a channel pocket across the back, which closes with a zip on each end. The inside lining has a removable elasticated waist snow skirt which fastens at the front with four snap fasteners. There are inside zipped pockets on each side and a headphone hole on the left. The sleeve cuffs have a cotton elastane grey inner layer mitten with thumb hole.
Country of Design: England
Country of Manufacture: China (garment), Switzerland (fabric)
Manufactured in Shenzhen, China by A-Garment.